Lesson Learned

You know how on the back of a spray paint can it says not to use it if the temperature is below 50 degrees? Well, my husband won’t allow me to spray paint in the house or garage (since I’m pregnant), so I just did some spray painting outside. It’s about 32 degrees. This is what happened: 


I’m spray painting jar lids for my craft room so I can put my cute stuff out all prettily.  



Fireplace Mantle Redo

We’ve finally completed something!! Well,,,… not fully. But… it looks good at least for now! No – not the entire living room. However, we have {almost} completed the fireplace/mantle. Here are some before pics:


Beautiful border with grapes and roses.


We love the fireplace with the wood stove insert. It was one of our favorite features of the house. However, the whole room was very outdated.

Here is the AFTER!


We took the border off the walls. Then we painted walls and ceiling a fresh coat of flat white. We sanded down all the wood wainscoting. We painted it all an eggshell white except for the gray mantle pieces above. I HATED it until i painted the brick gray too. Now i basically love it. Yes, i did paint the red ceramic tile below the fireplace with regular latex paint. That is why i say this is not fully completed yet. It obviously scratches off really easily and is not a permanent solution. We plan to re-tile eventually. I sure do love my mantle decor though 🙂


Here is a pretty before and after picture 🙂

Before and After

Things I’ve made in the past year

I don’t think I’ve blogged for almost a year!! I’ve made a few crafts here and there. I SHOULD make a separate post for each one… and in time maybe I will {?} but for now I just want to share the finished products.

The first dream catcher I made

The first dream catcher I made

The second dream catcher I made

The second dream catcher I made

Third dream catcher I made

Third dream catcher I made

Desk I built

Desk I built

1 Ugly red desk chair that I recovered

1 Ugly red desk chair that I recovered

Found a weird table in the trash room and took it fully apart and repainted

Found a weird table in the trash room and took it fully apart and repainted

Sign for bestie's wedding

Sign for bestie’s wedding

back side of sign for beastie's wedding

back side of sign for bestie’s wedding

Yes, I am proud of my rainbow order book shelf organization

Yes, I am proud of my rainbow order book shelf organization

Baby shower sign

Baby shower sign

Part of baby shower sign - Going to have to definitely make a post on baby shower because I made a ton of stuff (pictures are temporarily lost)

Part of baby shower sign – Going to have to definitely make a post on baby shower because I made a ton of stuff (pictures are temporarily lost)

Cutest cupcakes ever my sisters made for baby shower, also kind of a pinterest fail

Cutest cupcakes ever my sisters made for baby shower, also kind of a pinterest fail


Sexy Bachelorette Bag

This is SUPER easy and an awesome way to make your gift to a bachelorette stand out!! All you need is a bag, two bows, a pair of panties and some tape. Put a long, clear piece of tape on each side and pull tight in the back. Don’t be afraid to use a lot of long pieces of tape in the back since no one will really see it. This is easier to do if your bag sort of fits your panties. Small bags might not work.





Sea Glass End Table

I was inspired by those beer cap tables that I’ve seen a few times to make a ‘sea glass’ table. I used the decorative glass stones that you can buy at Michaels for about $3.75 per bag. I wish I would have taken more pictures throughout the process but I will try to explain thoroughly.


Above is the finished product.
List of supplies:

Small table
Glass gems
Glass Marbles
Spray paint (if you aren’t happy with the color of your table)
Sand paper (for spray painting)
Super glue
Blue painters tape
Duct tape
Tin foil
Mixing cups

Step 1:

Here was my beginning table. I sanded the top and used my favorite spray paint.


20140206-162158.jpg. Let dry over night.

Step 2:
Lay out your stones. I laid out one small circle, then super glued that circle.

After super gluing the first circle, I started laying out the rest of my stones. However, I realized I didn’t have enough (I bought 6 bags!). That is the reason i outlined the edge with the white glass marbles – I had them on hand and knew they would take up just enough space so that I wouldn’t need to go buy more glass stones. I superglued the marbles on as well.


I think it’s definitely best to lay out the stone pattern before gluing. I ended up switching stones around to make the pattern just how I wanted. And remember, you can use anything you want to cover your table with! Real beach glass, beads, sea shells, bottle caps, etc. You can lay out patterns with the glass stones and then throw in some colored rhinestones here and there (I almost did!).

Step 3:
Because my table was flat on top with no lip, I had to build a barrier so that the resin wouldn’t seep over the edges and onto the floor. I first covered the whole edge of my table in masking tape. Then I duct taped a wall of tin foil around the table top as a barrier. Make sure the tin foil is relatively even around the entire thing. Also make sure you get it as tight as possible. You don’t want any resin seeping down over the masking tape because then the tape gets hard to remove. I wasn’t as careful as I should have been.

Step 4:
Apply resin! Depending on the type of resin you get, this part might vary. Just follow the instructions on the box. I bought this kind.


I mixed the two chemicals 50-50 and stirred a ton, then poured over the table. I ended up not making enough resin – I made three batches total. You can see how much I used in the picture.

Step 5:
Let dry!


Homemade Lampshade Chandelier

I created these lampshade chandeliers for over the dessert table at my wedding. They were pretty simple!

Chandelier Chandelier2 Chandelier3 Chandelier4

To make:

  • Lampshades – I found some old ones from Goodwill. They can’t be the paper type – must have metal running both horizontally and vertically.
  • Scissors/other tools for ripping all the fabric off the lampshade frame
  • Fabric to cover the thin pieces of metal that make up the lampshade frame
  • Pretty beads
  • String for beading
  • Twine to tie the beaded strings up (you can use ribbon or anything you want)
  • Hot glue gun
  • Something to attach it to the ceiling – I used fish line and tied it over a beam so this was easy

Step 1:

Remove the fabric from the lampshade. This was the hardest part for me! Remember, it doesn’t have to be perfect because you are going to cover this with fabric.

Step 2:

Cut your fabric into long, thin strips. About an inch wide. Hot glue these strips around the metal pieces of the lampshade frame. If you look at the pictures, you can see that I didn’t cover all the metal on the frame. The fabric came off well on one of the lampshades and I was short on time so I figured it looked okay.

Step 3:

String beads. I counted, I think it was something like 15 of the small beads, then 1 or 3 of the big beads. Then 30 small beads (15 + 15) then the big beads, then the small beads and so on. I think i alternated between 15 small beads and 17 small beads to give it a slightly different look. If your lampshade is greatly different than the ones I used, you may find it prettier to use different numbers of beads.

Step 4:

Tie the bead strand onto the chandelier. I tied them up with the twine and made little bows. Make sure to count out the 15 small beads (or however many you used) to make sure you are tying them up at the correct spot. I hot glued each of these bows in place to make sure nothing would shift.

Step 5:



More Beer Cap Christmas Ornaments

Here are my beautiful ornaments!



They are super easy to make. I cut out circles of cardboard. Then I sprayed the cardboard with glitter spray paint. Next hot glue the bottle caps on. Lastly, hot glue on a ribbon to hang them from and a bow!